Performing initial operation with test run
WARNING: This page is about a different car, the 2011 BMW 750xi and 2010 BMW 750xi. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Risk of injury!
Vehicle executes heavy rolling motions during initial operation! Therefore observe the following instructions without fail:
Vehicle executes heavy rolling motions during initial operation! Therefore observe the following instructions without fail:
- Do not allow any persons to remain in the vehicle or directly on the vehicle
- Keep the vehicle doors closed.
- Maintain a safety distance around the vehicle of 1 meter to persons, objects, walls etc.
- Vehicle must be standing horizontally with all wheels on a firm surface
- Do not under any circumstances carry out initial operation on a lifting platform, wheel alignment analyzer or similar!
- Avoid heavy loads
- Check load; if necessary, remove load from the vehicle
- Bring engine up to operating temperature
- Connect vehicle to DIS or MoDiC
- Start initial operation in SERVICE FUNCTIONS. Follow instructions in Diagnosis and Information System.
- Check fill level again with engine stationary and if necessary top up oil to 80° mark.