37 14 055 Removing and installing/replacing Vertical Dynamics Management control unit (VDM with Dynamic Drive): Notes

WARNING: This page is about a different car, the 2011 BMW 750xi and 2010 BMW 750xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Remove ignition key
Disconnect BATTERY NEGATIVE LEAD
Remove SIDE TRIM PANEL FROM FOOTWELL ON RIGHT A-PILLAR

Fold carpet in footwell at bottom right to one side.

Release screws (1).

Tightening torque 37 14 6AZ .

Fig 1: Identifying Footwell Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections (1) in direction of arrow and disconnect.

Remove control unit.

Fig 2: Unlocking Control Unit Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.