67 31... Notes on initialization of electric seat actuator drives

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Initialization is carried out at the adjusting switch of the relevant seat.

In this process, the end positions of the relevant electric seat actuator drive are recorded and stored.

An initialization must be performed:

After replacing a drive unit for seat adjustment.
After replacing/programming control unit for seat adjustment.

Operating sequence for initialization:

Move corresponding seat actuator drive(s) into both end positions.