12 14 610 Removing/replacing right knock sensors (N63)

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Read out the fault memory of the DME control unit.
Switch off ignition.
Disconnect BATTERY EARTH LEAD .
Remove RIGHT INTAKE PLENUM .

Picture shows left side. Procedure on right side identical.

Unlock and disconnect plugs (1) on both knock sensors.

Release screws on both knock sensors (2).

Tightening torque 13 62 5AZ .

Remove knock sensors (3).

Fig 1: Identifying Knock Sensors, Plugs And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Clean support face of knock sensors on engine block.

Fig 2: Locating Knock Sensors Contact Surface On Engine Block

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault message.
Delete fault memory.