Installation location

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

On transmission housing at bottom right.

Release connector (1) and remove.

Release screw (2).

Tightening torque 13 62 4AZ .

Withdraw pulse generator (3) from transmission housing.

Fig 1: Identifying Pulse Generator, Connector And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Delete fault memory.