64 11 879 Replace control panel for heater/air conditioning system
WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD PROTECTION)
.
IMPORTANT:
Retrofitting must only be done in the supplied installation cassettes.
Use of supplied gloves is mandatory.
Carry out installation in a dust-free workshop area only.
To avoid damage, do not touch or dirty the display area.
Use of supplied gloves is mandatory.
Carry out installation in a dust-free workshop area only.
To avoid damage, do not touch or dirty the display area.
Necessary preliminary tasks:
- Remove RADIO AND IHKA CONTROLS
Disconnect plug connection (1).
Release short screw.
Tightening torque 61 31 2AZ .
Release long screws (2).
Tightening torque 61 31 2AZ .
Carefully unlock clamps (3).
Pull up and remove IHKA controls (4).
Installation note:
Assign buttons of IHKA controls depending on equipment.
Replacement:
Carry out VEHICLE PROGRAMMING/ENCODING .