64 11 545 Removing and installing blower housing for heating and air-conditioning unit

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove right/rear SUSPENSION CROSS-BRACE .
REMOVE auxiliary electronics box

Unlock plug connection (1) on AUC sensor (2) and disconnect.

Fig 1: Identifying Plug Connection And AUC Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on blower housing cover (2).

Lift out blower housing cover.

Fig 2: Identifying Blower Housing Cover And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on fan housing (2).

Unlock plug connections (3) and disconnect.

Carefully feed out fan housing (2).

Fig 3: Identifying Fan Housing, Plug Connections And Screws

Courtesy of BMW OF NORTH AMERICA, INC.