64 11 532 Replacing heat exchanger (heating and air-conditioning unit removed): Notes

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 030

Unclip deflection arm (1) from angle positioning lever (2).

Installation note:

Deflection arm (1) must snap audibly into place!

Fig 1: Identifying Deflection Arm And Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Unlock and disconnect plug connections on upper distributor housing (2).

Remove upper distributor housing (2).

Installation note:

Make sure filter housing guide lugs (3) are correctly seated in associated guide tabs on upper distributor housing (2).

Fig 2: Identifying Upper Distributor Housing, Filter Housing Guide Lugs And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove heat exchanger (2) in direction of arrow from filter housing (3).

Installation note:

Heat exchanger must be pushed correctly into designated guides on filter housing (3).

Fig 3: Removing Heat Exchanger From Filter Housing

Courtesy of BMW OF NORTH AMERICA, INC.