34 11 667 Precision-turning both front brake discs on both sides: Notes
WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Always precision-turn both sides of both brake discs on one axle.
Maximum machining dimension per friction ring side is 0.8 mm!
Observe minimum brake disc thickness (MIN TH). See FRONT BRAKE - TECHNICAL DATA or REAR BRAKE - TECHNICAL DATA .
Brake discs of M models (Compound brake discs) must not be machined!
Only one brake pad set may be used up on brake discs which have been lathe-turned to minimum thickness (MIN TH).
Maximum machining dimension per friction ring side is 0.8 mm!
Observe minimum brake disc thickness (MIN TH). See FRONT BRAKE - TECHNICAL DATA or REAR BRAKE - TECHNICAL DATA .
Brake discs of M models (Compound brake discs) must not be machined!
Only one brake pad set may be used up on brake discs which have been lathe-turned to minimum thickness (MIN TH).