17 11 046 Removing and installing/replacing module carrier (N63, N74)

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove RADIATOR .
REMOVE cooling loop for hydraulic steering

Release screws (1) on left and right on holder for module carrier.

Tightening torque 17 10 10AZ .

Fig 1: Identifying Holder Screws

G08504299

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Release holder (2) together with auxiliary water pump from module carrier.

Fig 2: Identifying Module Carrier Holder And Mounting Screws

G08504300

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Only with installed auxiliary radiator:

Unlock holders (1) from coolant pipe and pull off the module carrier toward the top.

Fig 3: Identifying Coolant Pipe Holder

G08504301

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Picture shows left side. Procedure on right side identical.

Lift module carrier (1) upwards slightly.

Disengage holder for module carrier (2) from bumper support (3).

Fig 4: Disengaging Module Carrier Holder From Bumper Support

G08504302

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Picture shows left side. Procedure on right side identical.

For purposes of clarity, the front bumper panel is shown removed.

Pull holder for module carrier (1) off module carrier (2), feed out and remove.

Fig 5: Removing Module Carrier Holder

G08504303

Courtesy of BMW OF NORTH AMERICA, INC.

Press module carrier (1) slightly towards rear. Then feed out module carrier (1) towards bottom and remove.

Fig 6: Removing Module Carrier

G08504304

Courtesy of BMW OF NORTH AMERICA, INC.

Reassemble the vehicle.