61 71 030 Removing and installing/renewing all washer jets of windscreen washer system

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

Turn clamp (3) in direction of arrow and washer fluid line (2) in direction of arrow.

Disconnect plug connection (1) and remove from holder (4).

Fig 1: Turning Clamp

Courtesy of BMW OF NORTH AMERICA, INC.

Press all washer jets (1) in direction of arrow upwards and remove.

Fig 2: Pressing Washer Jets

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Retaining lugs (1) must not be damaged.
Check ADJUSTMENT OF WASHER JETS and correct if necessary
Observe FILLING CAPACITY FOR WINDSCREEN WASHER SYSTEM

Fig 3: Identifying Retaining Lugs
Courtesy of BMW OF NORTH AMERICA, INC.