61 31 338 Removing and installing/replacing grip cover for gear selector switch (ceramic application, operating elements)

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

Carefully unclip knob cover (1) 00 9 322 with special tool at points (2) from gear selector switch (3) and remove in direction of arrow.

Fig 1: Removing Gear Selector Switch Knob Cover Using Special Tool

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove support (2).

Tightening torque 61 31 4AZ .

Fig 2: Identifying Gear Selector Switch Support And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Removed ceramic carrier (2) must not be reused.

Installation note:

Engagement lugs (1) of ceramic carrier (2) must not be damaged.

Fig 3: Identifying Engagement Lugs On Ceramic Carrier

Courtesy of BMW OF NORTH AMERICA, INC.