33 52 Shock Absorbers
WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - SHOCK ABSORBERS
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Nut and locknut/self-locking nut | F01 / F02 / F03 / F04 / F06 / F10 / F12 / F13 / F18 | M8 | Replace nuts. | 28 Nm |
| F07 / F11 | M8 | Replace screws. | 28 Nm | |
| F25 | M8 | Replace screws. Jointing torque and angle of rotation must be observed without fail. |
||
| Jointing torque | 25 Nm | |||
| Angle of rotation | 45 ° | |||
| 2AZ Support bearing flange to shock absorber | F01 / F02 / F04 / F06 / F07 / F10 / F11 / F12 / F13 / F18 | M12 | Replace nut. | 27 Nm |
| F25 | M12 | Replace nut. | 34 Nm | |
| 3AZ Shock absorber to wheel carrier | F01 / F02 / F04 / F06 / F10 / F12 / F13 / F18 | M16 | Replace screw. TIGHTEN DOWN IN NORMAL POSITION. | 250 Nm |
| F10 M5 / F12 M6 / F13 M6 | M14 | TIGHTEN DOWN IN NORMAL POSITION. | 165 Nm | |
| 4AZ Shock absorber to swinging arm | F07 / F11 | M14 | TIGHTEN DOWN IN NORMAL POSITION. | 165 Nm |
| 5AZ Spring strut to camber rod | F25 | M14 | Replace screw and nut. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 100 Nm | |||
| Angle of rotation | 90 ° |