33 53 000 Removing and installing/replacing rear left or right coil spring
WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.
Installation note:
- All screws, nuts, bolts and hose clamps removed during the repair must be replaced.
- Retaining elements on chassis and suspension and steering parts must be replaced.
IMPORTANT:
- Both coil springs on the relevant axle must be replaced in the event of corrosion breakage.
- The spring pads at the top and bottom must also be renewed when replacing the coil springs.
NOTE:
The coil spring is allocated in the Electronic Parts Catalogue (EPC) under the item "Spring table" after the vehicle identification number has been entered and the optional equipments of the car have been selected.
NOTE:
The process is described in HOW TO REPLACE REAR LEFT OR RIGHT SPRING STRUT .