13 62 592 Removing and installing/replacing pressure sensor on right charge air cooler (N63 B40/B44 O 0/1)

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Read out the fault memory of the DME control unit.
Switch off ignition
Remove right INTAKE DUCT .

Unlock connector (1) and remove.

Unfasten screws (2).

Tightening torque 13 62 7AZ .

Pull pressure sensor (3) out of right intercooler.

Installation note:

Replace sealing ring on pressure sensor.

Fig 1: Identifying Intercooler Pressure Sensor, Connector And Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Delete fault memory.