Replace Teflon ring

Before replacing the Teflon ring (1), make sure your hands and the work surface are clean and free of oil.

Avoid mechanical contact with injector tip (2).

Fig 1: Identifying Teflon Ring And Injector Tip

Courtesy of BMW OF NORTH AMERICA, INC.

Remove Teflon ring (1) with special tool 13 0 191 from injector (2).

Use a fluff-free cloth only to remove combustion residues from cylindrical part of injector tip (do not use ultrasound or other tools/agents).

Do not clean injector tip.

Fig 2: Removing Teflon Ring From Injector Using Special Tool (13 0 191)

Courtesy of BMW OF NORTH AMERICA, INC.

Push new Teflon ring (1) onto the installation cone 13 0 195 .

Fig 3: Identifying Teflon Ring Onto Installation Cone (13 0 195)

Courtesy of BMW OF NORTH AMERICA, INC.

Push Teflon ring (1) with fingers assisted by the installation cone 13 0 195 onto the injector (2).

Fig 4: Pushing Teflon Ring Onto Injector Using Fingers And Installation Cone (13 0 195)

Courtesy of BMW OF NORTH AMERICA, INC.

To bring the expanded Teflon ring to its installation dimension, slide three assembly sleeves with decreasing diameters onto the injector.

Slide assembly sleeve (1) with large opening first onto injector (1).

Do not use any lubricating agents.

Fig 5: Sliding Assembly Sleeve Onto Injector

Courtesy of BMW OF NORTH AMERICA, INC.

First slide assembly sleeve 13 0 192 (large diameter) onto injector (1).

Then slide assembly sleeve 13 0 193 (medium diameter) onto injector (1).

Fig 6: Sliding Slide Assembly 13 0 192 (Large Diameter) Onto Injector

Courtesy of BMW OF NORTH AMERICA, INC.

Finally, press injector (1) into assembly sleeve 13 0 194 (small diameter).

Installation note: 

Install injector within 10 minutes or slide on protective cap (Fig. 13 14 05) Teflon ring swells up.

Fig 7: Identifying Injector Into Assembly Sleeve 13 0 194 (Small Diameter)

Courtesy of BMW OF NORTH AMERICA, INC.