24 00 043 Installing replacement transmission (GA6HP26Z) (N63 engine, model years 2009 through 2012)
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Drain automatic transmission oil at oil drain plug.
Tightening torque 24 11 2AZ .
IMPORTANT:
After completing the tasks, program TCU control unit.
Recycling:
Catch and dispose of escaping transmission oil.
Observe country-specific waste-disposal regulations.
IMPORTANT:
- Before installing replacement transmission, always flush TRANSMISSION OIL COOLER TOGETHER WITH LINES .
- After completing work, check TRANSMISSION OIL LEVEL .
- Use only approved TRANSMISSION OIL
.
Failure to comply with this requirement will result in serious damage to the automatic transmission
Replacement transmission is supplied filled with transmission oil
Necessary preliminary tasks:
- Remove AUTOMATIC TRANSMISSION .
Modify gearshift lever (1).
Tightening torque 24 51 1AZ .
Modify clip (2) for cable.
Modify TRANSFER CASE .
Modify transportation retainers.
Convert all cable holders.
Convert all seal plugs.
Modify protective cap on output shaft.
IMPORTANT:
After removing transportation lock, secure torque converter against slipping out.
Transmission identification:
- On type plate