12 14 521 Replacing crankshaft pulse generator (N63)
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750i, and 2015 BMW 750Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary work
- Read out the fault memory of the DME control unit.
- Switch off ignition.
- Remove rear UNDERBODY PROTECTION .
Installation location
On transmission housing at bottom right.
Release connector (1) and remove.
Release screw (2).
Tightening torque 13 62 4AZ .
Withdraw pulse generator (3) from transmission housing.
Installation note:
Delete fault memory.