13 54 020 Removing and installing/sealing right throttle valve assembly (N63)

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750i, and 2015 BMW 750Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Switch off ignition.
Remove right INTERCOOLER .

NOTE: Picture shows the left throttle valve assembly, the procedure for the right side is identical.

Unlock plug (1) and remove.

Unfasten screws (2).

Tightening torque 13 54 1AZ .

Remove throttle valve assembly (3).

Fig 1: Identifying Throttle Valve Assembly, Plug And Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check plug connection (1) for coolant remnants. If necessary, clean plug connection (1) with compressed air.

Installation

Replace sealing ring (1) of throttle assembly (2).

Fig 2: Identifying Sealing Ring And Throttle Assembly

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check stored fault message.

Now clear the fault memory.