34 11 Front Brake
TIGHTENING TORQUE SPECIFICATION - FRONT BRAKE
| Type | Thread | Tightening specifications | Value | ||
|---|---|---|---|---|---|
| 1AZ | Brake disc to wheel hub | F01, F02, F03, F04, F07, F10, F11, F12, F18, F25 | M8 | Replace screws. | 16 Nm |
| 2AZ | Brake anchor plate to swivel bearing | F01, F02, F04, F07, F10, F11, F12, F18 | M12x1.5 | 110 Nm | |
| F03 | M14x1.5 | Replace screws.
IMPORTANT:
Observe 4 phase tightening!
|
|||
| Jointing torque | 150 Nm | ||||
| Release | min.90 ° | ||||
| Jointing torque | 150 Nm | ||||
| Angle of rotation | 180°± 15° | ||||
| F25 | M12x1.5 | Replace screws. | |||
| Jointing torque | 75 Nm | ||||
| Angle of rotation | 45°10° | ||||
| 3AZ | Protective plate to swivel bearing | F01, F02, F03, F04, F07, F10, F11, F12, F18, F25 | M6 | Replace screws. | 12 Nm |
| 4AZ | Guide bolt (brake caliper to brake anchor plate) | F01, F02, F03, F04, F07, F10, F11, F12, F18, F25 | SW9 | 55 Nm | |
| F10, F11, F12, F18, F25 | SW7 | 30-5 Nm | |||