11 34 552 Removing and installing/replacing all valves (N63)
Special tools required:
Necessary preliminary work:
- Remove both cylinder heads. See 11 12 105 REMOVING AND INSTALLING LEFT CYLINDER HEAD (N63) and 11 12 106 REMOVING AND INSTALLING RIGHT CYLINDER HEAD (N63) .
- Remove camshafts. See 11 31 036 REMOVING AND INSTALLING/REPLACING LEFT EXHAUST CAMSHAFT (N63) , 11 31 032 REMOVING AND INSTALLING/REPLACING LEFT INLET CAMSHAFT (N63) , 11 31 034 REMOVING AND INSTALLING/REPLACING RIGHT INLET CAMSHAFT (N63) and 11 31 038 REMOVING AND INSTALLING/RENEWING RIGHT EXHAUST CAMSHAFT (N63) .
Mount cylinder head (1) on special tool 11 9 000.
Prepare special tool 11 9 008 on special tool 11 9 006 .
Position special tool 11 9 006 with silicone cushion on cylinder head.
Slide locks (1) in direction of arrow and pretension with eccentric shaft.
Press down valve spring with special tool 11 8 840 .
Remove valve cotters (1) with a magnet.
Place valve springs and valve keys on special tool 11 4 480 in an orderly manner.
IMPORTANT:
Incorrect assembly possible.
Incorrect assembly will result in valve spring breakage.
Color marking (1) is normally on lower end of valve spring.
Only the diameter is decisive for the correct installation of the valve springs.
Install valve spring so that larger diameter points to spring plate at bottom.
Incorrect assembly will result in valve spring breakage.
Color marking (1) is normally on lower end of valve spring.
Only the diameter is decisive for the correct installation of the valve springs.
Install valve spring so that larger diameter points to spring plate at bottom.
Arrangement:
- Valve
- Valve stem seal with spring cup, bottom
- Valve spring
- Top spring cup
- Valve keys
Release special tool 11 9 006 from cylinder head.
Remove all valves and place on special tool 11 4 480 in an orderly manner.
Assemble engine.