34 11 Front Brake
TIGHTENING TORQUE SPECIFICATIONS - FRONT BRAKE
| Type | Thread | Tightening specifications | Value | ||
|---|---|---|---|---|---|
| 1AZ | Brake disc to wheel hub | F01/F02/F03/F04/F06/F07/F10/F11/F12/F13/F18/F25/F26 | M8 | Replace screws. | 16 Nm |
| 2AZ | Brake anchor plate to swivel bearing | F01, F02, F04, F06, F07, F10, F11, F12, F13, F18 | M12x1.5 | 110 Nm | |
| F03 | M14x1.5 | Replace screws. | |||
|
IMPORTANT:
Observe 4 phase tightening!
|
|||||
| Jointing torque | 150 Nm | ||||
| Release | min.90 ° | ||||
| Jointing torque | 150 Nm | ||||
| Angle of rotation | 180°± 15° | ||||
| F25/F26 | M12x1.5 | Replace screws. | |||
| Jointing torque | 75 Nm | ||||
| Angle of rotation | 45°10° | ||||
| 3AZ | Guard plate to swivel bearing | F01/F02/F03/F04/F06/F07/F10/F11/F12/F13/F18/F25/F26 | M6 | Replace screws. | 12 Nm |
| 4AZ | Guide bolt (brake caliper to brake anchor plate) | F01/F02/F03/F04/F06/F07/F10/F11/F12/F13/F18/F25/F26 | SW9 | 55 Nm | |
| F07/F06/F10/F11/F12/F13/F18/F25/F26 | SW7 | 30-5 Nm | |||
| F25/F26 | SW8 | 28 Nm | |||
| 5AZ | Brake caliper at swivel bearing | F06/F10/F12/F13/M models only | M12x1.5 | Hexagon nut | 95 Nm |
| 6AZ | Stud bolt (for brake caliper) in wheel carrier | F06/F10/F12/F13, M models only | Clean the thread in the wheel carrier and renew the stud bolt | 20 Nm | |