LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2013 >> 535xi >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine - Variable Valve Timing Control System (VANOS), Intake Plenum, Turbocharger, Water Pump, Thermostat, Coolant Lines, EGR Valve, EGR Cooler, Oxygen Sensors - Repair >> Intake Plenum >> S63 Engine >> 11 61 065 Removing and installing/replacing left intake plenum (S63)

11 61 065 Removing and installing/replacing left intake plenum (S63)

Necessary preliminary tasks: 

Disconnect plug connection (1) at servomotor for eccentric shaft (2).

Fig 1: Identifying Plug Connection and Eccentric Shaft
G09875056Courtesy of BMW OF NORTH AMERICA, INC.

Unclip wiring harness from clamps (1).

Disconnect plug connection (2).

Release screws (3).

Tightening torque: 13 62 2AZ .

Remove pressure sensor (4).

Installation note: 

Replace O-ring.

Fig 2: Identifying Pressure Sensor, Plug Connection, Clamps and Screws
G09875057Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts (1).

Tightening torque: 11 61 1AZ .

Remove intake plenum (2).

Fig 3: Identifying Intake Plenum And Nuts
G09875058Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Replace all sealing rings (1).

Observe mounting pin on the differentiated air intake system.

Fig 4: Identifying Sealing Ring
G09875059Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine and vehicle.

Check air intake system for leaks with diagnosis system.

  1. DME.
  2. Air supply.
  3. Charging pressure control.
  4. (ATL) exhaust turbocharger procedure.
scientia non olet · About LEMON Manuals