51 43 070 Removing and installing/replacing side trim panel, footwell, on A-pillar, left

Special tools required: 

• 00 9 317

Necessary preliminary tasks 

• Remove FRONT ENTRANCE COVER STRIP (INSIDE) .
• Remove trim panel for pedal assembly  . 

Release screw (1).

Remove handle from bonnet cable release.

Release screw (2).

Carefully lever out A-pillar trim panel (1) using special tool 00 9 317 .

Disconnect plug connection behind.

Installation note: 

Neatly fit A-pillar trim (1) into door seal.

Installation note: 

Make sure A-pillar trim panel (3) is correctly seated.

If necessary, replace both clips (1) and clamp (2).

Replacement 

• Modify clips (1)
• Modify luggage compartment locking system switch
  Fig 3: Removing Trim Panel From Roof Frame Using Special Tool (00 9 325)

  Courtesy of BMW OF NORTH AMERICA, INC.