67 62 020 Removing and installing/replacing flat motor for rear left or right power window regulator

Necessary preliminary work

Release screws (1) and detach flat motor (2) from power window regulator.

Tightening torque 67 62 1AZ.

Fig 1: Identifying Cutting And Punching Tool

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: For stress-free installation of the flat motor, fit journal (1) in guide (2)!

Fig 2: Sliding Special Tool (51 4 101) Into Door Trim Panel

Courtesy of BMW OF NORTH AMERICA, INC.

After installation

An initialization must be carried out in order to activate anti-trap mechanism.

Read and comply with NOTES on initialization of POWER WINDOW REGULATOR .