The following additionally applies
Shielded lines
Joins in the shield can cause problems with regard to noise radiation and interference immunity. Consequently, distinctions have to be drawn between the following types:
Coaxial lines
- Shielded RTK031 coaxial lines may only be repaired with special crimping tools.
CVBS lines
- CVBS cables may not be repaired.
- CVBS cables must be replaced in their entirety.
HSD lines
- HSD cables may not be repaired.
- HSD cables must be replaced in their entirety.
Optical fibre cable:
NOTE:
Fibre-optic cables are colored differently as follows:
- Green = MOST (M edia O riented S ystems T ransport) optical fibres
- Yellow = ISIS (I ntelligent S afety I ntegration S ystem) optical fibres
- Orange=repair fibre-optic cables
IMPORTANT:
- Optical fibres are permitted to show only one junction point (bridge). Replace optical fibres if necessary
- Smallest permissible bending radius is 25 mm
- Avoid effects of heat ≥ 85 °
TREATING CABLES AND FIBRE-OPTIC CABLES
FlexRay:
It is possible to repair the FlexRay. In the event of damage, the cables can be joined with conventional butt connectors and heat-shrink tubing . See 61 13... CUTTING OFF, STRIPPING INSULATION AND CUTTING OPTICAL FIBRES TO LENGTH or 61 13... CRIMPING OPTICAL FIBRES .
NOTE:
- FlexRay lines may only reveal one separation point (bride); renew complete line if necessary
- The cable is a twisted cable. If possible, maintain twisted cable after repair
Airbag lines: