51 16 165 Removing and installing complete center console

When working on trim panel components, make sure that the sensitive surfaces are not scratched or damaged.

Necessary preliminary tasks

IMPORTANT: Read and comply with notes on HANDLING WIRING HARNESSES and cables.

Release rear mat insert (1) from storage compartment at rear in direction of arrow.

Fig 1: Inserting Rear Mat

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: For purposes of clarity, illustration shows rear mat insert completely removed.

Release screws (1).

Tightening torque 51 16 22AZ .

Fig 2: Identifying Rear Mat Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out wiring harness (1) from holder and disengage USB / AUX IN socket (2) inward in direction of arrow.

Disconnect plug connection (3).

Fig 3: Disconnecting Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on center console support (near gear selector switch).

Tightening torque 51 16 22AZ .

Fig 4: Identifying Center Console Support Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) rear sides of center console support on left and right.

Tightening torque 51 16 22AZ .

Fig 5: Identifying Rear Sides Of Center Console Support Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws on front sides of center console support (1) on left and right.

Tightening torque 51 16 22AZ .

Fig 6: Identifying Front Sides Of Center Console Support Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on front of center console support on left and right.

Tightening torque 51 16 22AZ .

If necessary, disconnect plug connection from aerial for Comfort Access (2).

Lift center console slightly and, if necessary, disconnect remaining plug connections.

Pull out wiring harnesses from center console.

Carefully lift center console out towards rear at an angle.

Fig 7: Disconnecting Plug Connection From Aerial

Courtesy of BMW OF NORTH AMERICA, INC.

5116165 Removing and installing complete center console