51 71 346 Removing and installing / replacing right (rear) suspension cross-brace

IMPORTANT: Driving without the suspension cross-brace is not permitted! (risk of damage to the body).

Release expanding rivet (1) and remove cover (2).

Installation note:

Replace damaged expanding rivet.

Holder of cover (2) must snap into place in suspension cross-brace during installation.

Fig 1: Identifying Clamp And Clip Mounts

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque 51 61 1AZ .

Remove suspension cross-brace (2).

Installation note:

Make sure suspension cross-brace (2) is in correct installation position.

Replace screw (1).

Fig 2: Removing Vehicle Hoist Mounting And Vehicle Underbody Using Special Tool (51 3 330)

Courtesy of BMW OF NORTH AMERICA, INC.