51 47... Removing and installing/replacing cargo cover (middle) trim

When working on trim panel components, make sure that the sensitive surfaces are not scratched or damaged.

Necessary preliminary tasks

If necessary, tilt rear seat backrests forward
If necessary, fold cargo cover (middle) forwards.

Unclip lock trim (1) at marked locations and remove.

Fig 1: Identifying Plastic Hooks And Cargo Cover Trim

G08486112

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retaining clips (2) of lock trim (1) must not be bent or broken.

Fig 2: Identifying Carpet

G08486113

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 51 47 8AZ .

Fig 3: Identifying Cross Member

G08486114

Courtesy of BMW OF NORTH AMERICA, INC.

Fold cargo cover (middle) upwards.

Unhook cargo cover trim (1) towards top.

Fig 4: Identifying Clips

G08486115

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Plastic hooks (2) of cargo cover trim (1) must not be damaged.

Fig 5: Identifying Partition Wall Fixture Cover

G08486116

Courtesy of BMW OF NORTH AMERICA, INC.