37 14 511 Replacing front ride height sensor

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Release nut (1) and disconnect jointed rod (2).

Tightening torque 37 14 3AZ .

Installation note:

Replace nut.

Release screws (4).

Tightening torque 37 14 1AZ .

Remove ride height sensor and disconnect plug connection (3).

Fig 1: Identifying Nut, Jointed Rod And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Sensor lever (5) must point from ride height sensor to left front wheel.

After installation