66 31 001 Adjusting ACC sensor
Special tools required:
Unclip trim (1) at points (2) and remove towards front from bumper trim (3).
Installation:
Make sure trim (1) is correctly seated.
Locking hooks (2) must not be damaged.
E90/E91 up to build date 09/2008:
Installation:
If necessary, cut off front retaining lug (1) from trim (2).
- Distance: A = 10 mm
E90/E91 up to build date 09/2008:
IMPORTANT:
Before adjusting ACC sensor, check ease of movement at ACC sensor.
Measure gap dimension between front bumper trim (1) and ACC sensor (2).
- Minimum dimension: A = 3-5 mm
- Maximum dimension: A = 6-7 mm
If minimum dimension not obtained:
- Carry out preliminary work for ACC sensor adjustment.
Carry out adjustment of ACC sensor (1) with special tool 66 3 150 by means of adjusting screws (2).
Special tool required:
Active Cruise Control ACC adjusting device, complete.
Order number: 81 10 0 021 292
Consisting of:
- Mirror, complete
- Wheel laser
- Slotted diaphragm
- Control bracket (for initial installation of rail)
- Rail
- Setup and Owner's Handbook (not shown)
NOTE:
A holder which is not included in the scope of delivery is required to support the wheel laser. Use either the quick-action clamp from the existing KDS or ACC wheel holder (36 1 100
).
NOTE:
To adjust the ACC sensor, connect the BMW diagnosis system and fit the ACC adjusting device.
Select ACC system in diagnosis. Start test module "ACC adjustment" (service functions) and proceed in accordance with instructions.
Handle ACC adjusting device in accordance with mounting and Owner's Handbook provided with device.
Select ACC system in diagnosis. Start test module "ACC adjustment" (service functions) and proceed in accordance with instructions.
Handle ACC adjusting device in accordance with mounting and Owner's Handbook provided with device.
NOTE:
Further information on the ACC adjusting device can be found in the BMW Workshop Equipment and Planning Documentation.