67 11 610 Removing and installing/replacing servodrive in storage compartment

Necessary preliminary tasks

Release screws (1).

Lever out air duct (3) at catch (2) and feed out of storage compartment.

Fig 1: Identifying Air Duct, Catch And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

First feed air duct (1) to right out of guides (2) and duct (3), then remove to left out of storage compartment.

Installation:

Seal (4) must not be damaged.

Fig 2: Identifying Air Duct, Guides And Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip Bowden cable (1) from holder (2).

Release screws (3).

Remove servodrive (4).

Fig 3: Identifying Bowden Cable, Holder And Screws

Courtesy of BMW OF NORTH AMERICA, INC.