17 11 035 Removing and installing/replacing fan cowl with electric fan (N55 hybrid car)

WARNING: High-voltage system - danger to life!
The following points must be strictly observed prior to starting work :

Necessary preliminary work:

Release screw (1).

Tightening torque 17 10 4AZ .

Pull off transmission oil cooler (2) for automatic transmission in upward direction from fan cowl.

Fig 1: Identifying Transmission Oil Cooler And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and pull off connector (1) and unclip cable from fan cowl.

Unlock catch (2).

Release screw (3).

Tightening torque 17 10 1AZ .

Feed out fan cowl upwards and remove.

Fig 2: Pulling Fan Cowl Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure fan cowl (1) and holder (2) are in correct installation position.

Fig 3: Identifying Fan Cowl And Holder

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault messages.
Clear diagnostic fault entries from fault memory.