34 33 200 Removing and installing/replacing electric vacuum pump

WARNING: High-voltage system - danger to life!
The following points must be strictly observed prior to starting work:

Necessary preliminary work:

Release screws (1) from anti-roll bar.

Fig 1: Identifying Anti-Roll Bar And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace screws.

Tightening torque 31 35 1AZ .

Release screws (1) from auxiliary water pump holder.

Tightening torque 11 51 5AZ .

Secure auxiliary water pump (2) in sideways direction.

Fig 2: Identifying Auxiliary Water Pump And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure holders of auxiliary water pump (2) to retaining bracket are correctly seated.

Unlock plug connection (1) and disconnect.

Unlock and detach vacuum line (2).

Detach vent hose (3).

Fig 3: Identifying Vacuum Line And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

To facilitate installation, coat vent hose (3) with lubricant.

Turn connector (1) in direction of arrow and pull off from holder for electric vacuum pump.

Release screw (2).

Fig 4: Turning Electric Vacuum Pump Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Tightening torque 34 33 3AZ .

Feed electric vacuum pump out forwards.