51 46 011 Removing and installing (replacing) trim panel for storage shelf (version with through-loading system)

Necessary preliminary work:

Version with roller sunblind:

Release screws (1) on luggage compartment floor (2).

Tightening torque 51 46 3AZ .

Fig 1: Identifying Luggage Compartment Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) and expanding rivet (3).

Release door seal (5).

Detach cover (2) towards front with clamp (4) from body.

NOTE: Carry out work on the left side in the same way as for the right side illustrated here.

Installation note:

Clamp (4) must not be damaged or bent, replace if necessary.

Fig 2: Identifying Body Clamp, Door Seal And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Version with roller sunblind:

Release and disconnect plug connection (1) at right C-pillar.

Fig 3: Identifying Right C-Pillar Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Remove cover (1).

Pay attention to latches (2).

Remove cover (1) and feed out of seat belt (3).

Fig 4: Removing Seat Belt Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Release expanding rivet (1).

Slightly raise storage shelf (2) at front and unlock and detach plug connections underneath for speaker.

Remove storage shelf (2) toward the inside and feed out seat belt (3).

Fig 5: Identifying Seat Belt And Storage Shelf

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure storage shelf is correctly seated in ventilation grille (1).

Fig 6: Identifying Ventilation Grille

Courtesy of BMW OF NORTH AMERICA, INC.

In the case of replacement with appropriate version: