Condition for fault identification

Test condition:

The fault is recognized when the limits specified for the signal voltages (sensor 1 signal voltage < 0.27 V, sensor 2 > 4.73 V) are violated during the repeat adaptation routine (roughly 30 sec. at Terminal 15 without engine start) or the mutual deviation between the sum voltages for sensors 1 and 2 of 5 V is more than X V.

Potential problem source(s):

• Fault during repeat initialization attempt; lower mechanical travel limit range violation:;

1. 1.a. Travel stop dirty,
2. 1.b. Foreign object/matter
3. 1.c. Sporadic contact resistance
4. 1.d. Defective throttle valve

Terminal condition: Terminal 15

Voltage condition:

• Onboard electrical system voltage between 9 V and 16 V

Temperature condition:

• Engine warmed to normal temp, above 80 °C

Time condition:

• 30 sec. after Terminal 15 on

Other conditions:

• Engine on
• Vehicle velocity = 0 km/h