Condition for fault identification

Test condition:

The fault is recognized when a defect at sensor 2 or a clocking error [deviation between sensor 1 and sensor 2 > 6.3% throttle valve] is detected and comparison between sensor 1 and default value is greater than 14.9%.

Potential problem source(s):

• Defect in wiring harness between throttle-valve actuator motor and DME
• Throttle-valve sensor defective
• AD converter input on DME defective

Terminal condition: Terminal 15

Voltage condition:

• Onboard electrical system voltage between 9 V and 16 V

Temperature condition:

• None

Time condition:

• None

Other conditions:

• none