Condition for fault identification

Test condition:

In order to initialize the Valvetronic system, each time the DME control module wakes up, and each time terminals are changed on the DME, the upper travel stop is relearned. This fault is logged when the system fails to recognize the travel stop correctly.

Potential problem source(s):

• Valvetronic system travel stops damaged
• Friction in the Valvetronic system

Terminal condition: Terminal 15

Voltage condition:

• Onboard electrical system voltage between 9 V and 16 V

Temperature condition:

• Engine warmed to normal temp, above 80 °C

Time condition:

• None

Other conditions:

• Initialization of Valvetronic systems