17 00... Instructions for working on cooling system

WARNING: Danger of scalding! Work on the cooling system should only be carried out when the engine has cooled down.

IMPORTANT: Wear protective gloves and safety goggles.

IMPORTANT: Lifetime coolant filling:

Never reuse used coolant.

When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be drained and refilled.

In the case of other removal work involving the draining of partial quantities of coolant, replace these quantities which have been drained with new coolant.

IMPORTANT: Open cooling system only when it has cooled down.

Opening the cooling system while hot can result in air entering the system.

This can cause overheating with permanent damage to the engine.

IMPORTANT: You must protect the alternator against contamination before carrying out any work on the cooling circuit.

Cover alternator with suitable materials.

Failure to comply with this procedure may result in an alternator malfunction.

IMPORTANT: Do not fill coolant expansion tank over MAX level as overfilling will cause the coolant to overflow. This may give rise to traces of residual coolant on the expansion tank or in the engine compartment and wrongly suggest possible leakages.

Recycling

Catch and dispose of drained coolant.

Observe country-specific waste-disposal regulations.

NOTE: To disconnect coolant hoses, use commercially available disconnect tools such as HAZET brand tools (see table).

HAZET TOOLS DESCRIPTION CHART

HAZET no.:	Description
4590-1	Disconnect tool, length (mm): 150
4590-2	Disconnect tool, length (mm): 180
4590-3	Disconnect tool, length (mm): 253
4590/2	Disconnect/plier set
4590/3	Disconnect/plier set