12 61 588 Removing and installing/replacing engine oil pressure / temperature sensor (N20)
Special tools required:
Necessary preliminary work:
- Switch off ignition.
- Remove THROTTLE BODY .
WARNING:
Risk of burning!
Only perform this repair work on an engine that has cooled down.
Only perform this repair work on an engine that has cooled down.
Unlock connector (1) and remove.
Release engine oil pressure/temperature sensor (2) with special tool 34 5 160 .
Tightening torque 12 61 1AZ .
NOTE:
Add final details to vehicle
Check engine oil level. Top up engine oil if necessary.
Check engine oil level. Top up engine oil if necessary.