51 47 065 Removing and installing/replacing cover at front left or right entrance

IMPORTANT: Risk of damage!

Do not raise cover (2) over entire length simultaneously.

Unclip clips (1) for cover (2) with special tool 00 9 317.

Remove cover (2).

Fig 1: Removing Cover Using Special Tool (00 9 317)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Lever out remaining clips (1) in retaining holes with a suitable tool.

If necessary, slide missing clips (1) into clip mounts of cover.

Clip cover into retaining holes.

NOTE: Clips (1), clip mounts and retaining lugs of cover must not be damaged.

If necessary, replace faulty clips (1) or cover.

Fig 2: Identifying Clips

Courtesy of BMW OF NORTH AMERICA, INC.