17 11 035 Removing and installing/renewing fan cowl with electric fan (S63)

Necessary preliminary tasks:

Read out fault memory of DME control unit
Turn off ignition
Remove INTAKE FILTER HOUSING .

Unclip Bowden cable for engine bonnet/hood actuator from transverse reinforcement (1).

Release screws on left and right sides. Tightening torque 51 71 4AZ .

Remove cross-brace (1).

Installation:

Reinstall left and right holder for vacuum filter housing.

Fig 1: Identifying Cross-Brace And Screws

G04793950

Courtesy of BMW OF NORTH AMERICA, INC.

Release coolant hose (1) from fan cowl.

Fig 2: Identifying Coolant Hose On Fan Cowl

G06179178

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug (1) and remove.

Fig 3: Identifying Plug

G04794053

Courtesy of BMW OF NORTH AMERICA, INC.

Press lock (1).

Raise fan cowl (2) until holder (3) can be folded into centre of vehicle.

NOTE: For reasons of clarity, illustration and text show coolant hose removed.
Do not raise fan cowl by fan impeller.

Fig 4: Identifying Lock, Fan Cowl And Holder

G04794054

Courtesy of BMW OF NORTH AMERICA, INC.

Press lock (1).

Feed out fan cowl (2) towards top and remove.

Fig 5: Identifying Lock And Fan Cowl

G04794055

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert retaining tab (1) at bottom on module carrier.

Fig 6: Identifying Retaining Tab At Bottom On Module Carrier

G04794056

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault message.
Reassemble the vehicle.
Delete fault memory.