67 11 555 Removing and installing/replacing servodrive for tank filler flap

Necessary preliminary tasks:

Release screws (1).

Disengage emergency release mechanism (3).

Remove distribution board (2) and place to one side.

Fig 1: Identifying Emergency Release Mechanism, Distribution Board And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts (1) and feed out holder (2) towards rear.

Disconnect plug connection (3) and remove servodrive complete with holder (2).

Fig 2: Identifying Servodrive, Plug Connection, Holder And Mounting Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Turn sleeve (1) with a suitable tool (e.g.: pointed pliers) approx. 45° in direction of arrow and pull out of cover housing (2).

Fig 3: Pulling Cover Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slide sleeve (1) over locking pin (2).

Make sure sleeve (1) is correctly engaged in cover housing (3).

Fig 4: Sliding Sleeve Over Locking Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screws (1).

Disengage emergency actuation pull strap (2) from retainer (5) and remove towards front.

If necessary, unclip locking pin (3) in direction of arrow from servodrive for tank filler flap (4).

Fig 5: Disconnecting Locking Pin From Tank Filler Flap

Courtesy of BMW OF NORTH AMERICA, INC.