72 11 050 Removing and installing/replacing front anchor fitting tensioner (driver's seat only)
WARNING:
Read and comply with safety regulations
for handling airbag modules and pyrotechnical belt pretensioners, see 72 00.. Safety regulations for handling components with gas generators .
Improper handling can lead to triggering of the pyrotechnical seat belt pretensioner or side airbag, resulting in injuries.
Improper handling can lead to triggering of the pyrotechnical seat belt pretensioner or side airbag, resulting in injuries.
Switch off ignition!
Necessary preliminary tasks:
- Remove upper rail trim , see 52 14.. REMOVING AND INSTALLING OUTER UPPER RAIL TRIM .
NOTE:
A triggered anchor fitting tensioner can be recognized from the wrapped belt strap around the shaft.
If the anchor fitting tensioner has not been triggered, the shaft is visible.
If the anchor fitting tensioner has not been triggered, the shaft is visible.
Installation:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use
Detach cable tie.
Installation:
Replace faulty cable ties.
Plug connection must not be under tension.
Unlock plug connection (1) and disconnect.
Release screw (2).
Installation:
Replace screw (2).
Tightening torque 72 11 06AZ , see 72 11 SEAT BELTS .
Remove anchor fitting tensioner.
Release screw (1).
Tightening torque 72 11 07AZ , see 72 11 SEAT BELTS .
Remove lockplate.
Pull strap (2) out of anchor fitting tensioner.