72 11 092 Removing and installing/replacing rear left or right seat belt

Necessary preliminary tasks: 

• Remove rear seat  , see 52 26 001 REMOVING AND INSTALLING/REPLACING BOTH REAR SEATS .
• Remove panel for roof pillar  , see 51 43 259 REMOVING AND INSTALLING/REPLACING TRIM FOR REAR ROOF PILLAR (D-PILLAR), LEFT OR RIGHT .

Installation: 

• Microencapsulated screws (Loctite) must be replaced and may not  be reused
• Screw connection must be completed within 20 minutes (start of curing)
• Microencapsulated screws must not  be retightened
• Clean thread of nut beforehand in event of repeated use

Release screw (1) on end fitting.

Installation: 

Replace screw.

Tightening torque: 72 11 21AZ  , see 72 11 SEAT BELTS .

Installation: 

End fitting is coded against incorrect assembly.

Release screw (1).

Installation: 

Replace screw.

Tightening torque: 72 11 20AZ  , see 72 11 SEAT BELTS .

Remove inertial reel mechanism (2).

Installation: 

Inertia reel mechanism (2) is coded against incorrect installation.