12 61 280 Removing and installing/replacing oil pressure sensor (N63, S63)

Necessary preliminary tasks:

WARNING: Scalding hazard!
Only perform this task on an engine that has cooled down.

Recycling

Catch and dispose of drained engine oil in a suitable container.

Observe country-specific waste-disposal regulations.

Installation location

Oil pressure sensor is located next to the oil filter housing.

Engine oil may emerge when oil pressure sensor is replaced; have a cleaning cloth ready.

Unlock plug (1) and remove.

Release and remove oil pressure sensor (2).

Tightening torque 12 61 1AZ .

Installation:

Check engine oil level. Top up engine oil if level is too low.

Fig 1: Identifying Oil Pressure Sensor And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.