12 61 280 Removing and installing/replacing oil pressure sensor (N63, S63)
Necessary preliminary tasks:
- Turn off ignition
- Remove REINFORCEMENT PLATE
WARNING:
Scalding hazard!
Only perform this task on an engine that has cooled down.
Only perform this task on an engine that has cooled down.
Recycling:
Catch and dispose of drained engine oil in a suitable container.
Observe country-specific waste-disposal regulations.
Installation location:
Oil pressure sensor is located next to the oil filter housing.
Engine oil may emerge when oil pressure sensor is replaced; have a cleaning cloth ready.
Unlock plug (1) and remove.
Release and remove oil pressure sensor (2).
Tightening torque: 12 61 1AZ .
Installation:
Check engine oil level. Top up engine oil if level is too low.