51 24 015 Adjusting rear lid lock for rear lid lower section

Precondition:

Unclip trim (1) on left/right.

Installation note:

Catches on trim (1) must not be damaged.

Fig 1: Identifying Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Close lower rear lid section (3) and make sure it is correctly engaged in striker (1) on left/right.

Loosen left/right screws (2).

Press on lower rear lid section (3) until mucket (4) of rear lid (3) is slightly compressed.

Tighten down screws (2).

Tightening torque 51 24 3AZ .

Check closing comfort, repeat procedure if necessary.

NOTE: No grating noises must be heard when the closed rear lid is pressed slightly.

Fig 2: Identifying Lower Rear Lid Section, Striker, Screws, And Mucket

Courtesy of BMW OF NORTH AMERICA, INC.

Version with reversing camera:

After adjusting, CALIBRATE reversing camera.