51 16 080 Removing and installing or replacing sun visor and left or right counter support

When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).

Fold down sun visor (1) and detach from counter support (2).

Lever out cover (3) on counter support (2) and release screw underneath.

Remove counter supports (2).

Lever out cover (5) on joint and release screws (4).

Installation note: 

Cover (5) and cover (3) must not be damaged.

Pull down headlining (1) with suitable tool until plug connection (4) can be disconnected from cable (2).

Disconnect plug connection (4).

Pull down sun visor (3).

Installation note: 

Place plug connection (4) and cable (2) correctly back above headlining.

Perform function check of lighting for makeup mirror light.