51 14 110 Removing and installing/replacing rear model designation
IMPORTANT:
The "INSTRUCTIONS FOR NUMBER/LETTER COMBINATION CEMENTING " serve as the basis for these repair instructions and must be followed without fail.
Stick on top edge of adhesive tape (1) parallel to bottom edge of rear lid (2) at distance "A".
Mark measurement "B" from side edge (3) measured on top edge of adhesive tape.
Dimensions:
A = 20 mm; B = 57 mm
NOTE:
Measurement "C" is for information purposes only, as it is determined by carrier film.
C= 8.7 mm